HIGH SPEED AUTOMATIC VERTICAL LAMINATING MACHINE WITH HOT KNIFE

01-MACHINE FUNCTION AND STRUCTURE

NFM-EB fully Automatic Vertical High-precision and multi-duty lamination as a professional equipment used for plastic film laminating on the surface of paper printed matter.

1.Water-based gluing (waterborne polyurethane adhesive) dry laminating. (water-based glue, oil-based glue, non-glue film)

2.Thermal laminating (Pre-coated / thermal film)

3.Film: OPP, BOPP, PET, PVC

02-PARAMETER

03-DETAILS CONFIGURATION

FEEDING UNIT

1.Servo motor High Speed Feeder, 4 suckers for lifting and 4 suckers for conveying structure. Max Speed 12000 sheets/h.

2.The paper feeding table has upper and lower over-limit protection.

3.The height of non-stop feeding can reach 1300mm, pre-stacking device, non-stop feeding.

4.Non-stop paper feeder system enables continuous feeding without machine stop to minimize waste film.

5.BECKER Vacuum pump.

CONVEYING TABLE AND OVERLAP

1.The conveying table adopts customized stainless steel corrugated board.

2.The brush wheel and rubber pressing wheel move smoothly.

3.Servo motor overlap, improve accuracy of lap, error ≤±2mm.

HOT AND COLD FILM LAMINATOR HOST

1.Drying roller diameter increased to 900mm, using electromagnetic heating system.

2.Max pressure of press roller is 12T.

3.Gluing system Teflon process treatment, easy to clean and non-sticky.

4.Adopt double electromagnetic heating system, heating up and cooling down fast, temperature stability, heating steel roller using built-in temperature measuring

device, more accurate temperature measurement.

5.Glue thickness adjustment system, the glue thickness of conventional products is set before leaving the factory, customers can adjust the glue thickness with one key

cylinder. If there are many types, the adhesive thickness can be manually adjusted according to the product requirements.

CUTTING UNIT

1.The paper cutter is equipped with a tension controller and an anti-curl device to ensure that the paper is flat and not curled.

2.Standard configuration is hot knife cutter and disc knife, suitable for waterbase gluing and thermal BOPP/OPP/PVC/PET/Metal film.

3.The bounce roller is controlled by an independent motor, and the paper can be separated by using the speed difference.

4.Hobbing cutter structure, running speed fast.

5.The hot knife determines the cutting position by receiving the instantaneous thickness change signal of the paper through the sensor, the cutting accuracy 0.5mm.

6.Full paper sheet laminating, hot knife cutting.

7.Suitable for above 157gsm paper cutting, without tail film and make sure paper flat.

8.24V low voltage power supply, blade direct heating, safety guarantee.

NON-STOP COLLECTOR

1.The non-stop collector height can reach 1300mm. When the stack is almost full, the delivery conveyor belt will automatically extend to accept the paper. The collector

platform will drop. After the tray is replaced, the platform will recycle and complete the non-stop collector.

2.Adopt pneumatic paper sorting structure to ensure the neatness of the paper.

3.With a reduction wheel to prevent the paper from being damaged due to too fast hitting the baffle.

4.Induction electric eye, sensing the length of the paper, if the length of the paper changes, the belt will accelerate, and the baffle of the take-up machine will overturn and lift the paper.

5.Counting electric eye, the number of running paper is displayed on the display screen at the take-up machine, which can be cleared and accumulated.